ibaBM-DP-Product number: 13.121001-Iba-ag tại Việt Nam

ibaBM-DP

Product number: 13.121001

Bus module: Data acquisition on Profibus DP

Bus monitor for monitoring and analyzing the data traffic between master and slaves 

Technical data:

• Manufacturer: iba AG
• Power supply: 24 V DC ±10 % not stabilized, 2-pin connector, clamp-type terminal, screw connection, included in delivery
• Power consumption: Up to 12 W
• Rotary switch: Operating modes, device address (in the cascade)
• Indicators: 
  - 4 LEDs for device status 
  - 4 LEDs for each PROFIBUS status bus 0 and 1
  - 2 LEDs for Ethernet interface
• Ethernet: 10/100 Mbit/s, RJ45 socket
• Further interfaces: USB (for service purposes only) 
  -----
  PROFIBUS interfaces:
• D-Sub connectors: 2x 9-pin (bus 0, bus 1) for 2 drops
• Data rate: 9.6 kbit/s to 12 Mbit/s
• DP slaves: Up to 8, configurable, distributable to both DP drops, (extentable up to 16 with add-on license)
• Address range of the slaves: 1 to 126 
  -----
  ibaNet interface:
• Number: 1 (e. g. for the connection to ibaPDA)
• ibaNet protocols: 
  - 32Mbit Flex: Sampling time selectable from 0.5 ms (1540 Bytes), data volume dependent on cycle time 
  Number of signals: max. 1024 AI (BYTE, INT, WORD, DINT, DWORD, FLOAT, Big/Little Endian) + max. 1024 DI (bits), a total of max. 4060 Bytes 
  - 32Mbit (compatibility mode): Sampling time 1 ms 
  Number of signals: max 512 AI (BYTE, INT, WORD, DINT, DWORD, FLOAT, Big/Little Endian; up to 1984 Bytes) + max 512 DI (bits) 
  - 3Mbit (compatibility mode): Sampling time 1 ms 
  Number of signals: max 64 AI (INT or FLOAT) + max 64 DI (bits)
• Connectors: 2 ST connectors (62.5/125 µm) for RX and TX, 
  up to 2000 m cable length without repeater 
  -----
  Operating and environmental conditions:
• Cooling: Passive
• Operating temperature: 32 °F to 122 °F (0 °C to 50 °C)
• Protection class: IP20
• Mounting: DIN rail, vertical
• Standards: EMC: IEC 61326-1, FCC part 15 class A
• Dimensions (width x height x depth): 
  2.13 in x 7.40 in x 5.55 in (54 mm x 188 mm x 141 mm), 
  incl. DIN rail clip

Special remarks:

• A duplex FO cable for bi-directional communication with Flex-master (i.e. ibaFOB-D) is required that ibaPDA-V6 can use all device features
• If the device is used to replace the ibaBM- DPM-S, only one fiber optic link is needed

Weight: 1,00 kg

ibaBM-DP-Product number: 13.121001-Iba-ag tại Việt Nam